Logo

P0995 Engine Code Repair

Meaning of P0995 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P0995 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P0995 code is occuring now you should check P0995 repair processes.
Now don't ask yourself; What should you do with P0995 code ?
The solution is here :

P0995 Possible Solution:

P0995 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P0995 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

0
Intake Valve Control Solenoid Circuit Low

9
Engine Oil Temperature Sensor Malfunction

9
Ignition/Distributor Engine Speed Input Circuit Malfunction

5
Timing Reference High Resolution Signal A Too Many Pulses

Regarding the P0995 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P0995 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P0995 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For P0995 Code

The reason of P0995 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

P0995 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.